ACM is popular for barn quilts because it gives you a smooth, lightweight panel that does not have exposed wood edges. It is also a standard sign-making substrate, so cutting, drilling and mounting methods are well established.

The first thing to know is that “ACM” describes a family of products. The exact face coating can vary by manufacturer, so do not assume every sheet should be treated identically. Check the technical information for the panel you buy.

DIBOND, one major ACM product, lists painting, saw cutting, routing and mounting among recommended fabrication methods. Before coating any ACM, the surface should be clean and free from oil, grease, dirt and other contamination. Sherwin-Williams similarly recommends washing aluminum to remove oils and contamination before painting.

Many makers lightly scuff glossy ACM to improve mechanical adhesion, then clean away all sanding residue. Whether primer is necessary depends on the factory finish and the paint system. A hard, slick or non-porous surface may benefit from a bonding primer, but the safest approach is to use a primer that explicitly supports the substrate and to test adhesion on a scrap piece first.

Do not aggressively sand through the aluminum face coating. You are trying to improve adhesion, not expose or damage the composite.

After preparation, draw or transfer the pattern and paint with compatible coatings. Because ACM does not absorb paint like bare wood, thin even coats are usually easier to control than heavy ones.

ACM can be drilled with conventional tools. If the quilt will be outdoors, think about the mounting system before painting so you know where holes, clips or cleats may go. On large panels, allow for thermal movement and wind load rather than treating the quilt like a small indoor picture.

The biggest advantage of ACM is that you remove many of the moisture problems associated with wood-based panels. The tradeoff is that adhesion and mounting deserve more deliberate planning.