Crisp lines are a huge part of the barn quilt look, so painter's tape gets discussed almost as much as paint itself. In the community material we reviewed, FrogTape came up repeatedly, with many makers preferring yellow Delicate Surface tape over recently painted areas and green Multi-Surface tape on more durable surfaces.
Another useful tip is if you’re taping on or next to a section that’s the same color as your tape, try using another color of suitable tape so it’s easier to see where your new paint line will be.
The difference is useful. Yellow Delicate Surface tape has lower adhesion and is designed for sensitive surfaces, including latex paint that has dried at least 24 hours. Green Multi-Surface has stronger adhesion and is better suited to fully cured, durable surfaces. We don't all have the patience or time to wait 24 hours between each paint color, so do your best to respect the manufacturer recommendations while being prepared to do touchups if you need to work faster. Many makers use fans or blow dryers to speed up the drying time.
Whichever tape you choose, technique matters just as much as brand. The surface should be clean, dry and free from dust. Lay the tape accurately, then burnish the paint-side edge firmly with a smooth plastic card or similar tool.
For especially important edges, use the base-color sealing trick. After applying the tape, brush a thin coat of the color already underneath along the tape edge. If anything seeps beneath the tape, it is the matching base color. Once that coat sets, apply the contrasting color. This same trick works beautifully with vinyl masks and stencils.
Avoid flooding paint against the tape. Several lighter coats are less likely to creep under an imperfect edge than one heavy coat.
Tape should also be removed thoughtfully. FrogTape recommends removing its painter's tapes while the paint is still wet for sharp lines. If the paint has already formed a film over the tape edge, score the edge carefully before peeling so the new paint film does not tear.
Finally, do not assume “dry to touch” paint is ready for aggressive tape. Use delicate tape over newer paint, let coats cure appropriately and test when in doubt. A perfect line is not worth pulling the previous color off the board.